Casual Fan
Surprisingly nice
Sorry, from the side, so I can see how much saddle you have above the bridge.
This angle (minus the dude's fingers):
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Thanks. It looks like you have plenty of saddle for us to play with. Remind me at some point to have you look under the saddle for any plastic shims under it. Removing one of those (if they're there) can solve this high action problem. More when you report back on the nut action and the truss rod.
I'm sorry, but this post sounds dirty to me. :lolsign:
You don't understand. This kind of work needs to be started about 11 pm, so that when your guitar is in pieces on the floor with two broken strings about 3 in the morning, you can say, "Why the fuck did I think this was a good idea?"
And that's how you learn.
And that's probably how it will wind up, too.
I'm getting a premonition of CF's obit --
"Casual Fan was tragically flattened by a tractor trailer today in a misguided attempt to create rock and roll."
Also, do the nut action test: http://www.frets.com/FretsPages/Musician/GenSetup/NutAction/nutaction.html
And the test to see if you have your truss rod adjusted right:
http://www.taylorguitars.com/global/pdfs/truss_rod_adjustment.pdf
With the truss rod test, you should just barely see daylight under the low E at the sixth fret. You should be able to tap the string at that fret and hear a tiny little "plink" as the string taps the fret.
There is a gap between the sixth string and the fret, but it's a little bigger than the picture shows. Not A LOT bigger, but there's definitely more daylight between the string and the fret.
Okay, this is where it gets fun. Follow the directions in the Taylor document to take some of the bow or concavity out of the guitar neck. The only difference should be that your truss rod access hole (snicker) is in the soundhole, not in the headstock (double snicker). You'll need whatever size Allen wrench fits in the hole. I would turn it one quarter turn, tune it (it will now be out of tune), and re-check the action at the sixth fret. If it looks pretty damn close but doesn't touch the fret wire, strum all six strings pretty aggressively and make sure there is no fret buzzing. If there is, back the truss rod off 1/8 turn counterclockwise, retune, and check the action again.
Next--the saddle.
I clicked on that taylor document. Says 'page not found'.